Waste oil

Waste oil is defined as any petroleum-based or synthetic oil that, through contamination, has become unsuitable for its original purpose due to the presence of impurities or loss of original properties. Waste oil is defined as any petroleum-based or synthetic oil that, through contamination, has become unsuitable for its original purpose due to the presence of impurities or loss of original properties. The U.S. EPA defines the term 'used oil' as any petroleum or synthetic oil that has been used, and as a result of such use is contaminated by physical or chemical properties. 'Used oil' is a precise regulatory term. 'Waste oil' is a more generic term for oil that has been contaminated with substances that may or may not be hazardous. Any oil contaminated with hazardous waste may itself be a hazardous waste, and if so, must be managed subject to hazardous waste management standards. Both used oil and waste oil require proper recycling or disposal to avoid creating an environmental problem. Some examples of types of products that after use, can be labeled as used oil are: hydraulic oil, transmission oil, brake fluids, motor oil, crankcase oil, gear box oil, synthetic oil, and grades 1, 2, 3 and 4 fuel oil. Waste oil can be disposed of in different ways, including sending the used oil off-site (some facilities are permitted to handle the used oil such as your local garages and local waste disposal facilities), burning used oil as a fuel (some used oil is not regulated by burner standards, but others that are off-specification used oil can only be burned in either industrial furnaces, certain boilers, and permitted hazardous waste incinerators), and marketing the used oil (claims are made that the used oil is to be burned for energy recovery, it is then shipped to a used oil burner who burns the used oil in an approved industrial furnace or boiler).Oils that are off-specification typically contain: Arsenic 5 ppm, Cadmium 2 ppm, Chromium 10 ppm, Lead 100 ppm, Flash point 100°F, minimum (i.e., fp must be greater than 100°F), Total Halogens >4,000 ppm For on-site burning of used oil, the oil must be stored in tanks or containers, above or underground. The containers must be in good condition with no leaks, the tanks/containers must be labeled with the words “used oil”, and there must be a spill prevention plan (or a control and countermeasures plan).