Gas meter prover

A gas meter prover is a device which verifies the accuracy of a gas meter. Provers are typically used in gas meter repair facilities, municipal gas meter shops, and public works shops. Provers work by passing a known volume of air through a meter while monitoring the gas meters register, index, or internal displacement. The prover then displays a proof, a value expressed as a percent which compares the volume of air passed with the volume of air measured to determine the meters accuracy. A gas meter prover is a device which verifies the accuracy of a gas meter. Provers are typically used in gas meter repair facilities, municipal gas meter shops, and public works shops. Provers work by passing a known volume of air through a meter while monitoring the gas meters register, index, or internal displacement. The prover then displays a proof, a value expressed as a percent which compares the volume of air passed with the volume of air measured to determine the meters accuracy. Since the early 1900s, bell provers have been the most common reference standard used in gas meter proving, and has provided standards for the gas industry that is unfortunately susceptible to a myriad of immeasurable uncertainties. A bell prover (commonly referred to in the industry as a 'bell') consists of a vertical inner tank surrounded by an outer shell. A space between the inner tank and outer shell is filled with a sealing liquid, usually oil. An inverted tank, called the bell, is placed over the inner tank. The liquid provides an air-tight seal. Bell provers are typically counterweighted to provide positive pressure through a hose and valve connected to a meter. Sometimes rollers or guides are installed on the moving part of the bell which allows for smooth linear movement without the potential for immeasurable pressure differentials caused by the bell rocking back or forth. Bells provide a volume of air that may be predetermined by calculated temperature, pressure and the effective diameter of the bell. Bell scales are unique to each bell and are usually attached vertically with a needle-like pointer. When proving a meter using a manually controlled bell, an operator must first fill the bell with a controlled air supply or raise it manually by opening a valve and pulling a chained mechanism, seal the bell and meter and check the sealed system for leaks, determine the flow rate needed for the meter, install a special flow-rate cap on the meter outlet, note the starting points of both the bell scale and meter index, release the bell valve to pass air through the meter, observe the meter index and calculate the time it takes to pass the predetermined amount of air, then manually calculate the meter's proof accounting for bell air and meter temperature and in some cases other environmental factors.