Catch bond

A catch bond is a type of noncovalent bond whose dissociation lifetime increases with tensile force applied to the bond. Normally, bond lifetimes are expected to diminish with force. In the case of catch bonds, the lifetime of the bond actually increases up to a maximum before it decreases like in a normal bond. Catch bonds work in a way that is conceptually similar to that of a Chinese finger trap. While catch bonds are strengthened by an increase in force, the force increase is not necessary for the bond to work. Catch bonds were suspected for many years to play a role in the rolling of leukocytes, being strong enough to roll in presence of high forces caused by high shear stresses, while avoiding getting stuck in capillaries where the fluid flow, and therefore shear stress, is low. The existence of catch bonds was debated for many years until strong evidence of their existence was found in bacteria. Definite proof of their existence came shortly thereafter in leukocytes. A catch bond is a type of noncovalent bond whose dissociation lifetime increases with tensile force applied to the bond. Normally, bond lifetimes are expected to diminish with force. In the case of catch bonds, the lifetime of the bond actually increases up to a maximum before it decreases like in a normal bond. Catch bonds work in a way that is conceptually similar to that of a Chinese finger trap. While catch bonds are strengthened by an increase in force, the force increase is not necessary for the bond to work. Catch bonds were suspected for many years to play a role in the rolling of leukocytes, being strong enough to roll in presence of high forces caused by high shear stresses, while avoiding getting stuck in capillaries where the fluid flow, and therefore shear stress, is low. The existence of catch bonds was debated for many years until strong evidence of their existence was found in bacteria. Definite proof of their existence came shortly thereafter in leukocytes. Catch bonds were first proposed in 1988 in the Proceedings of the Royal Society by M. Dembo et al. while at Harvard University. While studying the critical tension required to detach a membrane bound to a surface through adhesion molecules, it was found that some adhesion molecules bound more tightly in response to tensions higher than the critical tension. The term 'catch bonds' was coined by Dembo to explain these unexpected observations. No decisive evidence of catch bonds was found until 2003. This is due to experimental conditions that were unfavorable for detecting catch bonds, as well as the counterintuitive nature of the bonds themselves. For example, most early experiments were conducted in 96 well plates, an environment that does not provide any flow. Some experiments failed to produce shear stress that is now known to be critical to lengthen the lifetimes of catch bonds, while other experiments conducted under flow conditions too weak or too strong for optimal shear-induced strengthening of these bonds. Finally, Marshall and coworkers found that L-selectin:PSGL-1 bonds exhibited increasing bond lifetime as step loads were applied between 0 and ~25 pN, and fell exponentially at higher loads. These data were collected using an atomic force microscope, and have subsequently been duplicated using a biomembrane force probe and in shear flow assays. L-selectin:PSGL-1 bonds display catch bond behavior at low loads, and slip bond behavior (meaning that bond lifetime decreases with increasing load) at high loads ('catch-slip' bonds). Catch-slip behavior has also been reported for dissociation of L-selectin from endoglycan, P-selectin from PSGL-1, FimH from mannose, and myosin from actin. Emphasizing their importance and general acceptance, in the three years following their discovery there were at least 24 articles published on catch bonds. Recently, Sivasankar and his research team have found that the mechanism behind the puzzling phenomenon is due to long-lived, force-induced hydrogen bonds. Using data from previous experiments, the team used molecular dynamics to discover that two rod-shaped cadherins in an X-dimer formed catch bonds when pulled and in the presence of calcium ions. The calcium ions keep the cadherins rigid, while pulling brings the proteins closer together, allowing for hydrogen bonds to form. The mechanism behind catch bonds helps to explain the biophysics behind cell-cell adhesion. According to the researchers, 'Robust cadherin adhesion is essential for maintaining the integrity of tissue such as the skin, blood vessels, cartilage and muscle that are exposed to continuous mechanical assault.' Leukocytes, as well as other types of white blood cells, normally form weak and short-lived bonds with other cells via selectin. Coated outside the membrane of leukocytes are microvilli, which have various types of adhesive molecules, including P-selectin glycoprotein ligand-1 (PSGL-1), a glycoprotein that is normally decorated with sulfated sialyl-Lewis x. the sulfated-sialyl-Lewis-x-contained PSGL-1 molecule has the ability to bind to any type of selectin. Leukocytes also exhibit L-selectin that binds to other cells or other leukocytes that contain PSGL-1 molecules. An important example of catch bonds is their role in leukocyte extravasation. During this process, leukocytes move through the circulatory system to sites of infection, and in doing so they 'roll' and bind to selectin molecules on the vessel wall. While able to float freely in the blood under normal circumstances, shear stress induced by inflammation causes leukocytes to attach to the endothelial vessel wall and begin rolling rather than floating downstream. This “shear-threshold phenomenon” was initially characterized in 1996 by Finger et al. who showed that leukocyte binding and rolling through L-selectin is only maintained when a critical shear-threshold is applied to the system. Multiple sources of evidence have shown that catch bonds are responsible for the tether and roll mechanism that allows this critical process to occur. Catch bonds allow increasing force to convert short-lived tethers into stronger, longer-lived binding interactions, thus decreasing the rolling velocity and increasing the regularity of rolling steps. However, this mechanism only works at an optimal force. As shear force increases past this force, bonds revert to slip bonds, creating an increase in velocity and irregularity of rolling. In blood vessel, at very low shear stress of ~.3 dynes per squared centimeter, leukocytes do not adhere to the blood vessel endothelial cells. Cells move along the blood vessel at a rate proportional to the blood flow rate. Once the shear stress pass that shear threshold value, leukocytes start to accumulate via selectin binding. At low shear stress above the threshold of about .3 to 5 dynes per squared centimeter, leukocytes alternate between binding and non-binding. Because one leukocyte has many selectins around the surface, these selectin binding/ unbinding cause a rolling motion on the blood vessel. As the shear stress continue to increase, the selectin bonds becomes stronger, causing the rolling velocity to be slower. This reduction in leukocytes rolling velocity allow cells to stop and perform firm binding via integrin binding. Selectin binding do not exhibit 'true' catch bond property. Experiments show that at very high shear stress (passing a second threshold), the selectin binding transit between a catch bond to a slip bond binding, in which the rolling velocity increases as the shear force increases. Researchers have hypothesized that the ability of leukocytes to maintain attachment and rolling on the blood vessel wall can be explained by a combination of many factors, including cell flattening to maintain a larger binding surface-area and reduce hydrodynamic drag, as well as tethers holding the rear of the rolling cell to the endothelium breaking and slinging to the front of the rolling cell to reattach to the endothelial wall. These hypotheses work well with Marshall’s 2003 findings that selectin bonds go through a catch-slip transition in which initial increases in shear force strengthen the bond, but with enough applied force bond lifetimes begin to decay exponentially. Therefore, the weak binding of a sling at the leading edge of a rolling leukocyte would initially be strengthened as the cell rolls farther and the tension on the bond increases, preventing the cell from dissociating from the endothelial wall and floating freely in the bloodstream despite high shear forces. However, at the trailing edge of the cell, tension becomes high enough to transition the bond from catch to slip, and the bonds tethering the trailing edge eventually break, allowing the cell to roll further instead of remaining stationary. Though catch bonds are now widely recognized, their mechanism of action is still under dispute. Two leading hypotheses dominate the discussion. The first hypothesis, the allosteric model, stems from evidence that x-ray crystallography of selectin proteins shows two conformational states: a bent conformation in the absence of ligand, and an extended conformation in the presence of the ligand. The main domains involved in these states are a lectin domain which contains the ligand binding site and an EGF domain which can shift between bent and extended conformations. The allosteric model claims that tension on the EGF domain favors the extended conformation, and extension of this domain causes a conformational shift in the lectin domain, resulting in greater binding affinity for the ligand. As a result of this conformational change, the ligand is effectively locked in place despite tension exerted on the bond.