Chrysotile

Chrysotile or white asbestos is the most commonly encountered form of asbestos, accounting for approximately 95% of the asbestos in the United States and a similar proportion in other countries. It is a soft, fibrous silicate mineral in the serpentine subgroup of phyllosilicates; as such, it is distinct from other asbestiform minerals in the amphibole group. Its idealized chemical formula is Mg3(Si2O5)(OH)4. The material has physical properties which make it desirable for inclusion in building materials, but poses serious health risks when dispersed into air and inhaled. Chrysotile or white asbestos is the most commonly encountered form of asbestos, accounting for approximately 95% of the asbestos in the United States and a similar proportion in other countries. It is a soft, fibrous silicate mineral in the serpentine subgroup of phyllosilicates; as such, it is distinct from other asbestiform minerals in the amphibole group. Its idealized chemical formula is Mg3(Si2O5)(OH)4. The material has physical properties which make it desirable for inclusion in building materials, but poses serious health risks when dispersed into air and inhaled. Three polytypes of chrysotile are known. These are very difficult to distinguish in hand specimens, and polarized light microscopy must normally be used. Some older publications refer to chrysotile as a group of minerals—the three polytypes listed below, and sometimes pecoraite as well—but the 2006 recommendations of the International Mineralogical Association prefer to treat it as a single mineral with a certain variation in its naturally occurring forms. Clinochrysotile is the most common of the three forms, found notably at Asbestos, Quebec, Canada. Its two measurable refractive indices tend to be lower than those of the other two forms. The orthorhombic paratypes may be distinguished by the fact that, for orthochrysotile, the higher of the two observable refractive indices is measured parallel to the long axis of the fibres (as for clinochrysotile); whereas for parachrysotile the higher refractive index is measured perpendicular to the long axis of the fibres. Bulk chrysotile has a hardness similar to a human fingernail and is easily crumbled to fibrous strands composed of smaller bundles of fibrils. Naturally-occurring fibre bundles range in length from several millimetres to more than ten centimetres, although industrially-processed chrysotile usually has shorter fibre bundles. The diameter of the fibre bundles is 0.1–1 µm, and the individual fibrils are even finer, 0.02–0.03 µm, each fibre bundle containing tens or hundreds of fibrils.Chrysotile fibres have considerable tensile strength, and may be spun into thread and woven into cloth. They are also resistant to heat and are excellent thermal, electrical and acoustic insulators. The idealized chemical formula of chrysotile is Mg3(Si2O5)(OH)4, although some of the magnesium ions may be replaced by iron or other cations. Substitution of the hydroxide ions for fluoride, oxide or chloride is also known, but rarer. A related, but much rarer, mineral is pecoraite, in which all the magnesium cations of chrysotile are substituted by nickel cations. Chrysotile is resistant to even strong bases (asbestos is thus stable in high pH pore water of Portland cement), but the fibres are attacked by acids: the magnesium ions are selectively dissolved, leaving a silica skeleton. It is thermally stable up to around 550 °C (1,022 °F), at which temperature it starts to dehydrate. Dehydration is complete at about 750 °C (1,380 °F), with the final products being forsterite (magnesium silicate), silica and water.