TR-069

Technical Report 069 (TR-069) is a technical specification of the Broadband Forum that defines an application layer protocol for remote management of customer-premises equipment (CPE) connected to an Internet Protocol (IP) network. TR-069 uses the CPE WAN Management Protocol (CWMP) which provides support functions for auto-configuration, software or firmware image management, software module management, status and performance managements, and diagnostics. Technical Report 069 (TR-069) is a technical specification of the Broadband Forum that defines an application layer protocol for remote management of customer-premises equipment (CPE) connected to an Internet Protocol (IP) network. TR-069 uses the CPE WAN Management Protocol (CWMP) which provides support functions for auto-configuration, software or firmware image management, software module management, status and performance managements, and diagnostics. The CPE WAN Management Protocol is a bidirectional SOAP- and HTTP-based protocol, and provides the communication between a CPE and auto configuration servers (ACS). The protocol addresses the growing number of different Internet access devices such as modems, routers, gateways, as well as end-user devices which connect to the Internet, such as set-top boxes, and VoIP-phones. TR-069 was first published in May 2004, with amendments in 2006, 2007, 2010, July 2011 (version 1.3), and November 2013 (version 1.4 am5) Other technical initiatives, such as the Home Gateway Initiative (HGI), Digital Video Broadcasting (DVB) and WiMAX Forum endorsed CWMP as the protocol for remote management of residential networking devices and terminals. CWMP is a text based protocol. Orders sent between the device (CPE) and auto configuration server (ACS) are transported over HTTP (or more frequently HTTPS). At this level (HTTP), the CPE acts as client and ACS as HTTP server. This essentially means that control over the flow of the provisioning session is the sole responsibility of the device. All communications and operations are performed in the scope of the provisioning session. The session is always started by the device (CPE) and begins with the transmission of an Inform message. Its reception and readiness of the server for the session is indicated by an InformResponse message. That concludes the session initialization stage. The order of the next two stages depends on the value of the flag HoldRequests. If the value is false the initialization stage is followed by the transmission of device requests, otherwise ACS orders are transmitted first. The following description assumes the value is false. In the second stage, orders are transmitted from the device to the ACS. Even though the protocol defines multiple methods that may be invoked by the device on the ACS, only one is commonly found - TransferComplete - which is used to inform the ACS of the completion of a file transfer initiated by a previously issued Download or Upload request. This stage is finalized by transmission of empty HTTP-request to the ACS. In the third stage the roles change on the CWMP level. The HTTP-response for the empty HTTP-request by the device will contain a CWMP-request from the ACS. This will subsequently be followed by an HTTP-request containing a CWMP-response for the previous CWMP-request. Multiple orders may be transmitted one-by-one. This stage (and the whole provisioning session) is terminated by an empty HTTP-response from the ACS indicating that no more orders are pending.