Boosted fission weapon

A boosted fission weapon usually refers to a type of nuclear bomb that uses a small amount of fusion fuel to increase the rate, and thus yield, of a fission reaction. The neutrons released by the fusion reactions add to the neutrons released due to fission, allowing for more neutron-induced fission reactions to take place. The rate of fission is thereby greatly increased such that much more of the fissile material is able to undergo fission before the core explosively disassembles. The fusion process itself adds only a small amount of energy to the process, perhaps 1%. A boosted fission weapon usually refers to a type of nuclear bomb that uses a small amount of fusion fuel to increase the rate, and thus yield, of a fission reaction. The neutrons released by the fusion reactions add to the neutrons released due to fission, allowing for more neutron-induced fission reactions to take place. The rate of fission is thereby greatly increased such that much more of the fissile material is able to undergo fission before the core explosively disassembles. The fusion process itself adds only a small amount of energy to the process, perhaps 1%. The alternative meaning is an obsolete type of single-stage nuclear bomb that uses thermonuclear fusion on a large scale to create fast neutrons that can cause fission in depleted uranium, but which is not a two-stage hydrogen bomb. This type of bomb was referred to by Edward Teller as 'Alarm Clock', and by Andrei Sakharov as 'Sloika' or 'Layer Cake' (Teller and Sakharov developed the idea independently, as far as is known). The idea of boosting was originally developed between late 1947 and late 1949 at Los Alamos. The primary benefit of boosting is further miniaturization of nuclear weapons as it reduces the minimum inertial confinement time required for a supercritical nuclear explosion by providing a sudden influx of fast neutrons before the critical mass would blow itself apart. This would eliminate the need for an aluminum pusher and uranium tamper and the explosives needed to push them and the fissile material into a supercritical state. While the bulky Fat Man had a diameter of 5 feet (1.5 m) and required 3 tons of high explosives for implosion, a boosted fission primary can be fitted on a small nuclear warhead (such as the W88) to ignite the thermonuclear secondary. In a fission bomb, the fissile fuel is 'assembled' quickly by a uniform spherical implosion created with conventional explosives, producing a supercritical mass. In this state, many of the neutrons released by the fissioning of a nucleus will induce fission of other nuclei in the fuel mass, also releasing additional neutrons, leading to a chain reaction. This reaction consumes at most 20% of the fuel before the bomb blows itself apart, or possibly much less if conditions are not ideal: the Little Boy (gun type mechanism) and Fat Man (implosion type mechanism) bombs had efficiencies of 1.38% and 13%, respectively. Fusion boosting is achieved by introducing tritium and deuterium gas. Solid lithium deuteride-tritide has also been used in some cases, but gas allows more flexibility (and can be stored externally) and can be injected into a hollow cavity at the center of the sphere of fission fuel, or into a gap between an outer layer and a 'levitated' inner core, sometime before implosion. By the time about 1% of the fission fuel has fissioned, the temperature rises high enough to cause thermonuclear fusion, which produces relatively large numbers of neutrons, speeding up the late stages of the chain reaction and approximately doubling its efficiency. Deuterium-tritium fusion neutrons are extremely energetic, seven times more energetic than an average fission neutron, which makes them much more likely to be captured in the fissile material and lead to fission. This is due to several reasons: Taking these factors into account, the maximum alpha value for D-T fusion neutrons in plutonium (density 19.8 g/cm³) is some 8 times higher than for an average fission neutron (2.5×109 vs 3×108). A sense of the potential contribution of fusion boosting can be gained by observing that the complete fusion of one mole of tritium (3 grams) and one mole of deuterium (2 grams) would produce one mole of neutrons (1 gram), which, neglecting escape losses and scattering for the moment, could fission one mole (239 grams) of plutonium directly, producing 4.6 moles of secondary neutrons, which can in turn fission another 4.6 moles of plutonium (1,099 g). The fission of this 1,338 g of plutonium in the first two generations would release 23 kilotons of TNT equivalent (97 TJ) of energy, and would by itself result in a 29.7% efficiency for a bomb containing 4.5 kg of plutonium (a typical small fission trigger). The energy released by the fusion of the 5 g of fusion fuel itself is only 1.73% of the energy released by the fission of 1,338 g of plutonium. Larger total yields and higher efficiency are possible, since the chain reaction can continue beyond the second generation after fusion boosting. Fusion-boosted fission bombs can also be made immune to neutron radiation from nearby nuclear explosions, which can cause other designs to predetonate, blowing themselves apart without achieving a high yield.The combination of reduced weight in relation to yield and immunity to radiation has ensured that most modern nuclear weapons are fusion-boosted.