Boiler explosion

A boiler explosion is a catastrophic failure of a boiler. As seen today, boiler explosions are of two kinds. One kind is a failure of the pressure parts of the steam and water sides. There can be many different causes, such as failure of the safety valve, corrosion of critical parts of the boiler, or low water level. Corrosion along the edges of lap joints was a common cause of early boiler explosions.'The principal causes of explosions, in fact the only causes, are deficiency of strength in the shell or other parts of the boilers, over-pressure and over-heating. Deficiency of strength in steam boilers may be due to original defects, bad workmanship, deterioration from use or mismanagement.''Cause.-Boiler explosions are always due to the fact that some part of the boiler is, for some reason, too weak to withstand the pressure to which it is subjected. This may be due to one of two causes: Either the boiler is not strong enough to safely carry its proper working pressure, or else the pressure has been allowed to rise above the usual point by the sticking of the safety valves, or some similar cause''A cylindrical boiler was tested and withstood a steam pressure of 300 pounds without injury.' ' When the valve was suddenly opened at a pressure of 235 pounds the boiler gave way, the iron being twisted and torn into fragments and thrown in all directions. The reason for this was that the sudden rush of steam from the boiler into the discharge pipe reduced the pressure in the boiler very rapidly. This reduction of pressure caused the sudden formation of a great quantity of steam within the water, and the heavy mass of water being thrown with great violence toward the opening whence the steam was being withdrawn, struck the portions of the boiler near that opening and caused the fracture.''The sudden dispersion and projection of the water in the boiler against the bounding surfaces of the boiler is the great cause of the violence of the results: the dispersion, being caused by the momentary generation of steam throughout the mass of the water, and in its efforts to escape, it carries the water before it, and the combined momentum of the steam and the water carries them like shot through and amongst the bounding surfaces, and deforms or shatters them in a manner not to be accounted for by simple overpressure or by simple momentum of steam.''The expansion caused by this heating process caused water hammer as water was accelerated upwards toward the reactor vessel head, producing approximately 10,000 pounds per square inch (69,000 kPa) of pressure on the head of the reactor vessel when water struck the head at 160 feet per second (50 m/s) ...This extreme form of water hammer propelled control rods, shield plugs, and the entire reactor vessel upward. A later investigation concluded that the 26,000-pound (12,000 kg) vessel had jumped 9 feet 1 inch (2.77 m) and the upper control rod drive mechanisms had struck the ceiling of the reactor building prior to settling back into its original location' A boiler explosion is a catastrophic failure of a boiler. As seen today, boiler explosions are of two kinds. One kind is a failure of the pressure parts of the steam and water sides. There can be many different causes, such as failure of the safety valve, corrosion of critical parts of the boiler, or low water level. Corrosion along the edges of lap joints was a common cause of early boiler explosions. The second kind is a fuel/air explosion in the furnace, which would more properly be termed a firebox explosion. Firebox explosions in solid-fuel-fired boilers are rare, but firebox explosions in gas or oil-fired boilers are still a potential hazard.