Bo He

Chengdu University of Technology

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Trends

Author Order

Document Type

Co-Authors

Lingzhi Xie

Kunming University of Science and Technology

Ying Xia Yu

Shenzhen University

Peng Zhao

Huainan Normal University

Jian Ping Shi

China Academy of Railway Sciences

Jun Liu

Sichuan University

Baode Sun

Shanghai Jiao Tong University

Yi Du

Qilu University of Technology

Fei Li

Craft Group (China)

Fei Li

Jiangsu Province Special Equipment Safety Supervision and Inspection Institute

Bo Huang

Nanjing University of Aeronautics and Astronautics

Cooperative Institutions

Chinese Academy of Sciences

102

Sichuan University

Shanghai Jiao Tong University

Huazhong University of Science and Technology

Harbin Institute of Technology

University of Chinese Academy of Sciences

Zhejiang University

University of Science and Technology of China

Xi'an Jiaotong University

Tsinghua University

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Field

Reconstruction-based multivariate contribution analysis for fault isolation: A branch and bound approach

Journal of Process Control (2012)

Bo He Xianhui Yang Tao Chen Jie Zhang

Benchmark (surveying)

Identification

Component (thermodynamics)

Branch and bound

10.1016/j.jprocont.2012.05.010

Cite

Citations (47)

EFFECTS OF FEEDSTOCK pH, INITIAL CO ADDITION, AND TOTAL SOLIDS CONTENT ON THE THERMOCHEMICAL CONVERSION PROCESS OF SWINE MANURE

Transactions of the ASAE (2001)

Bo He Y. Zhang Yao Yin T. L. Funk G. L. Riskowski

The effects of feedstock pH, ratio of initial carbon monoxide to volatile solids (CO/VS), and total solids contentof the feedstock on the thermochemical conversion process of swine manure were studied. The pH values of the feedstockranged from 4 to 10. High pH values favored oil production in the biomass conversion process. When the feedstock pH was10, the process yielded the highest oil production efficiency, but the benzene solubles of the oil product was 10% lower thanthose at pH 7, pH 4, and without pH control. The CO/VS ratio varied from 0.07 to 0.25, while the corresponding carbonmonoxide initial pressure ranged from 0.69 to 2.76 MPa. The oil production efficiency increased from 55% to 70% as theCO/VS ratio increased from 0.07 to 0.25. The COD reduction, on the other hand, decreased to 50%, while the CO/VS ratioincreased to 0.25. A CO/VS ratio higher than 0.1 is not recommended. Total solids of the feedstock were studied from 10%to 25%. The total solids content of the feedstock directly affected the effectiveness of the process. The higher the total solidscontent, the higher the oil production and COD reduction efficiencies, limited by the handling capability of the feedstock.

Total dissolved solids

10.13031/2013.6108

Cite

Citations (28)

Influence of anisotropic and heterogeneous permeability coupled with in-situ stress on CO2 sequestration with simultaneous enhanced gas recovery in shale: Quantitative modeling and case study

International journal of greenhouse gas control (2020)

Jun Liu Lingzhi Xie Bo He Quan Gan Peng Zhao

10.1016/j.ijggc.2020.103208

Cite

Citations (51)

Research on the Impact Force of Rockfall Impacting Sand Cushions with Different Shapes

Applied Sciences (2022)

Yu Zhang Lingzhi Xie Bo He Peng Zhao

Shed structures are an important engineering method for mountain highways to resist rockfall impacts. Research on the rockfall impact response is very important to the design of rockfall disaster protection structures to shed cave structures. To explore the impact difference caused by different rockfall shapes, five mortar ellipsoids were fabricated with different shapes by 3D printing the falling stone mould. Laboratory experiments were carried out to study the impact effect of five different shapes of falling stones on the sand cushion. Different shapes of rockfall correspond to different impact forces. The tip ellipsoid (D1 and D2) is the smallest, the sphere (D3) is the second, and the flat ellipsoid (D4 and D5) is the largest. The fitting analysis of the impact force results of the laboratory experiment showed that the impact of the falling height on the impact force was relatively independent and did not change with the shape of the falling rock. Then, based on the impact force of the sphere falling rock, a calculation formula of the impact force with the introduction of the shape factor was obtained, and it was compared and verified with the test results from other studies. To study the applicability of the formula in the actual engineering scale, a numerical model was established by ANSYS. After verifying the reliability of the numerical model, the impact process of a large energy level was simulated. According to the simulation results, the rationality of the formula proposed in this paper is further verified, which guides the actual rockfall impact prevention and control engineering.

Rockfall

Impact

Ellipsoid

Falling (accident)

10.3390/app12073540

Cite

Citations (5)

Hydrothermal Synthesis VO₂(B) Nanorod/MoS₂ Nanosheet Heterostructures for Enhanced Performance Lithium-ion Battery Anodes

Chemistry Letters (2019)

Shize Zeng Chunrui Wang Hui Li Jiale Wang Xiaofeng Xu

In this work, VO2(B) nanorod/MoS2 nanosheet heterostructures with MoS2 nanosheets grown on VO2(B) nanorods have been synthesized by a two-step hydrothermal method. The VO2(B) nanorod/MoS2 nanosheet...

Nanosheet

Nanorod

Hydrothermal Synthesis

Hydrothermal reaction

10.1246/cl.180916

Cite

Citations (4)

Correction to: Composition and diversity of the fungal community in the rhizosphere soil of halophytic vegetation in Ebinur Lake wetland

Environmental Science and Pollution Research (2024)

Cheng Ding Wenge Hu Xue Zhang Xiaoyun Qi Bo He

10.1007/s11356-024-35783-5

Cite