Homogeneous observations and careful analysis of transit light curves can lead to the identification of transit timing variations (TTVs). TrES-2 is one of few exoplanets, which offer the matchless possibility to combine long-term ground-based observations with continuous satellite data. Our research aimed at the search for TTVs that would be indicative of perturbations from additional bodies in the system. We also wanted to refine the system parameters and the orbital elements. We obtained 44 ground-based light curves of 31 individual transit events of TrES-2. Eight 0.2 - 2.2-m telescopes located at six observatories in Germany, Poland and Spain were used. In addition, we analysed 18 quarters (Q0-Q17) of observational data from NASA's space telescope Kepler including 435 individual transit events and 11 publicly available ground-based light curves. Assuming different limb darkening (LD) laws we performed an analysis for all light curves and redetermined the parameters of the system. We also carried out a joint analysis of the ground- and space-based data. The long observation period of seven years (2007-2013) allowed a very precise redetermination of the transit ephemeris. For a total of 490 transit light curves of TrES-2, the time of transit mid-point was determined. The transit times support neither variations on long time-scale nor on short time-scales. The nearly continuous observations of Kepler show no statistically significant increase or decrease in the orbital inclination i and the transit duration D. Only the transit depth shows a slight increase which could be an indication of an increasing stellar activity. In general, system parameters obtained by us were found to be in agreement with previous studies but are the most precise values to date.
There have been previous hints that the transiting planet WASP-3 b is accompanied by a second planet in a nearby orbit, based on small deviations from strict periodicity of the observed transits. Here we present 17 precise radial velocity measurements and 32 transit light curves that were acquired between 2009 and 2011. These data were used to refine the parameters of the host star and transiting planet. This has resulted in reduced uncertainties for the radii and masses of the star and planet. The radial-velocity data and the transit times show no evidence for an additional planet in the system. Therefore, we have determined the upper limit on the mass of any hypothetical second planet, as a function of its orbital period.
Abstract The ExoClock project has been created to increase the efficiency of the Ariel mission. It will achieve this by continuously monitoring and updating the ephemerides of Ariel candidates, in order to produce a consistent catalog of reliable and precise ephemerides. This work presents a homogenous catalog of updated ephemerides for 450 planets, generated by the integration of ∼18,000 data points from multiple sources. These sources include observations from ground-based telescopes (the ExoClock network and the Exoplanet Transit Database), midtime values from the literature, and light curves from space telescopes (Kepler, K2, and TESS). With all the above, we manage to collect observations for half of the postdiscovery years (median), with data that have a median uncertainty less than 1 minute. In comparison with the literature, the ephemerides generated by the project are more precise and less biased. More than 40% of the initial literature ephemerides had to be updated to reach the goals of the project, as they were either of low precision or drifting. Moreover, the integrated approach of the project enables both the monitoring of the majority of the Ariel candidates (95%), and also the identification of missing data. These results highlight the need for continuous monitoring to increase the observing coverage of the candidate planets. Finally, the extended observing coverage of planets allows us to detect trends (transit-timing variations) for a sample of 19 planets. All the products, data, and codes used in this work are open and accessible to the wider scientific community.
We report the confirmation and characterization of four hot Jupiter-type exoplanets initially detected by TESS: TOI-1295 b, TOI-2580 b, TOI-6016 b, and TOI-6130 b. Using observations with the high-resolution echelle spectrograph MaHPS on the 2.1 m telescope at Wendelstein Observatory, together with NEID at Kitt Peak National Observatory and TRES at the Fred Lawrence Whipple Observatory, we confirmed the planetary nature of these four planet candidates. We also performed precise mass measurements. All four planets are found to be hot Jupiters with orbital periods between 2.4 and 4.0 days. The sizes of these planets range from 1.29 to 1.64 Jupiter radii, while their masses range from 0.6 to 1.5 Jupiter masses. Additionally, we investigated whether there are signs of other planets in the systems but have found none. Lastly, we compared the radii of our four objects to the results of an empirical study of radius inflation and see that all four demonstrate a good fit with the current models. These four planets belong to the first array of planets confirmed with MaHPS data, supporting the ability of the spectrograph to detect planets around fainter stars as faint as V = 12.
We report on our ongoing search for timing, duration, and depth variations in the exoplanet TrES-2. In Raetz et al. (2009) we already presented ten different transits obtained at the University Observatory Jena. Between November 2008 and August 2010 twelve additional transits could be observed. The timing, depth and duration of each individual event was analyzed and is presented here.
The Ariel mission will observe spectroscopically around 1000 exoplanets to further characterise their atmospheres. For the mission to be as efficient as possible, a good knowledge of the planets' ephemerides is needed before its launch in 2028. While ephemerides for some planets are being refined on a per-case basis, an organised effort to collectively verify or update them when necessary does not exist. In this study, we introduce the ExoClock project, an open, integrated and interactive platform with the purpose of producing a confirmed list of ephemerides for the planets that will be observed by Ariel. The project has been developed in a manner to make the best use of all available resources: observations reported in the literature, observations from space instruments and, mainly, observations from ground-based telescopes, including both professional and amateur observatories. To facilitate inexperienced observers and at the same time achieve homogeneity in the results, we created data collection and validation protocols, educational material and easy to use interfaces, open to everyone. ExoClock was launched in September 2019 and now counts over 140 participants from more than 15 countries around the world. In this release, we report the results of observations obtained until the 15h of April 2020 for 119 Ariel candidate targets. In total, 632 observations were used to either verify or update the ephemerides of 83 planets. Additionally, we developed the Exoplanet Characterisation Catalogue (ECC), a catalogue built in a consistent way to assist the ephemeris refinement process. So far, the collaborative open framework of the ExoClock project has proven to be highly efficient in coordinating scientific efforts involving diverse audiences. Therefore, we believe that it is a paradigm that can be applied in the future for other research purposes, too.
We report follow-up observations of transiting exoplanets that have either large uncertainties (>10 minutes) in their transit times or have not been observed for over three years. A fully robotic ground-based telescope network, observations from citizen astronomers and data from TESS have been used to study eight planets, refining their ephemeris and orbital data. Such follow-up observations are key for ensuring accurate transit times for upcoming ground and space-based telescopes which may seek to characterise the atmospheres of these planets. We find deviations from the expected transit time for all planets, with transits occurring outside the 1 sigma uncertainties for seven planets. Using the newly acquired observations, we subsequently refine their periods and reduce the current predicted ephemeris uncertainties to 0.28 - 4.01 minutes. A significant portion of this work has been completed by students at two high schools in London as part of the Original Research By Young Twinkle Students (ORBYTS) programme.
Abstract The ExoClock project is an inclusive, integrated, and interactive platform that was developed to monitor the ephemerides of the Ariel targets to increase the mission efficiency. The project makes the best use of all available resources, i.e., observations from ground telescopes, midtime values from the literature, and finally, observations from space instruments. Currently, the ExoClock network includes 280 participants with telescopes capable of observing 85% of the currently known Ariel candidate targets. This work includes the results of ∼1600 observations obtained up to 2020 December 31 from the ExoClock network. These data in combination with ∼2350 midtime values collected from the literature are used to update the ephemerides of 180 planets. The analysis shows that 40% of the updated ephemerides will have an impact on future scheduling as either they have a significantly improved precision or they have revealed biases in the old ephemerides. With the new observations, the observing coverage and rate for half of the planets in the sample has been doubled or more. Finally, from a population perspective, we identify that the differences in the 2028 predictions between the old and the new ephemerides have an STD that is double what is expected from Gaussian uncertainties. These findings have implications for planning future observations, where we will need to account for drifts potentially greater than the prediction uncertainties. The updated ephemerides are open and accessible to the wider exoplanet community both from our Open Science Framework repository and our website.
'%3e%3cpath fill='%23012169' d='M0 0v30h60V0z'/%3e%3cpath stroke='%23fff' stroke-width='6' d='m0 0 60 30m0-30L0 30'/%3e%3cpath stroke='%23C8102E' stroke-width='4' d='m0 0 60 30m0-30L0 30' clip-path='url(%23b)'/%3e%3cpath stroke='%23fff' stroke-width='10' d='M30 0v30M0 15h60'/%3e%3cpath stroke='%23C8102E' stroke-width='6' d='M30 0v30M0 15h60'/%3e%3c/g%3e%3c/svg%3e)
