Mohammad Hadi Zare

Islamic Azad University, Science and Research Branch

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Trends

Author Order

Document Type

Co-Authors

Amirhossein Meysami

University of Utah

Reza Beiranvand

Tarbiat Modares University

Ahmad Mirzaei

Yazd University

Hossein Askarian Abyaneh

Amirkabir University of Technology

Shirin Mahmoudi

Islamic Azad University Central Tehran Branch

Mahmoud Hajisafari

Islamic Azad University, Yazd

Mustafa Mohamadian

Tarbiat Modares University

M. Mazar Atabaki

Southern Methodist University

M. Mondali

Islamic Azad University, Science and Research Branch

Navid Nezafat

Shiraz University of Medical Sciences

Cooperative Institutions

Shiraz University of Medical Sciences

Biotechnology Research Center

Shiraz University

Iran University of Science and Technology

University of Tehran

Tarbiat Modares University

Southern Methodist University

Islamic Azad University, Science and Research Branch

Islamic Azad University, Tehran

Sharif University of Technology

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Field

Probiotic Potential of Five Lactobacillus Strains Isolated from Traditional Persian Yoghurt in Fars province, Iran: Viewing Through the Window of Phylogenetics

Biosciences Biotechnology Research Asia (2015)

Mohammad Hadi Zare Milad Mohkam Mohammad Hossein Morowvat Navid Nezafat Younes Ghasemi

Southern Iran

10.13005/bbra/1780

Cite

Citations (7)

Improving capacitive voltage transformer response and its impact on distance relay performance

Mohammad Hadi Zare Ahmad Mirzaei Hossein Askarian Abyaneh

Capacitive voltage transformer (CVT) has an ideal steady state response at the system power frequency, while its dynamic response is inferior. This may lead to the mis-operation of distance relays during a fault. This paper presents a new method in order to correct CVT transient response. The proposed method is able to eliminate transients emerging in the CVT output for various fault conditions and CVT parameters in the real-time. The simulation results reveal that the modified CVT exhibits a low percentage error. Moreover, the percentage overreach of distance relay connected to the modified CVT is considerably reduced.

Transient (computer programming)

10.1109/iraniancee.2012.6292413

Cite

Citations (1)

Quasi-resonant switch-mode isolated lithium-ion battery charger with CC-CV modes of operations using secondary side controller

Alireza Lahooti Eshkevari Mohammad Hadi Zare

This paper presents a quasi-resonant switch-mode isolated battery charger for charging Lithium-Ion (Li-Ion) batteries. It has two modes of operation: constant current (CC) and constant voltage (CV). The quasi-resonant flyback topology is selected to implement this charger because it has a few parts. It is controlled by the accurate and cost-effective secondary side analog controller which has the appropriate feedback loop compensation. The charging current is controlled by the output current control loop. This charger has low output voltage ripple and high efficiency too. The operation and performance of this charger have been verified by the experimental results. For this purpose a 12.6V, 2000mA Li-Ion charger is designed for charging three series 3.7V, 2200mAh Li-Ion batteries.

Battery charger

Constant current

10.1109/iraniancee.2017.7985205

Cite

Citations (6)

Simulation of fluid flow and solididification in the funnel type crystalizer of thin slab continuous cast

Oriental Journal Of Chemistry (2013)

Mohammad Hadi Zare Amirhossein Meysami Shirin Mahmoudi Mahmoud Hajisafari M MazarAtabaki

Oriental Journal of Chemistry is a peer reviewed quarterly research journal of pure and applied chemistry. It publishes standard research papers in almost all thrust areas of current chemistry of academic and commercial importance. It provides a platform for rapid publication of quality research papers, reviews and chemistry letters. Oriental Journal of Chemistry is abstracted and indexed in almost all reputed National and International agencies.

Material chemistry

Industrial chemistry

Elsevier Biobase

Funnel

FLUIDEX

10.13005/ojc/290408

Cite

Citations (8)

Simulation of flow field and steel/slag interface in the mold region of a thin slab steel continuous caster with tetra-furcated nozzle

Journal of Manufacturing Processes (2013)

Mohammad Hadi Zare Amirhossein Meysami Shirin Mahmoudi Mahmoud Hajisafari M. Mazar Atabaki

Caster

Slab

10.1016/j.jmapro.2012.12.004

Cite

Citations (10)

Single‐stage AC module with series power decoupling capability for connecting PV to a single‐phase power grid

IET Power Electronics (2016)

Mohammad Hadi Zare Mustafa Mohamadian Reza Beiranvand

In single‐phase grid‐connected photovoltaic inverters, the input power is constant during the grid period, whereas the output power oscillates at double‐line frequency. Therefore, electrolytic capacitors are widely used to handle the input and output power differences. However, these capacitors have short lifetime which degrade the inverter reliability. This paper proposes a control strategy to turn a conventional four‐switch flyback‐based inverter to an inverter equipped with a series power decoupling circuit. Therefore, a long lifetime film capacitor can be used as the main energy storage. The modified inverter has an inherent snubber circuit, which can restore energy of the transformer leakage inductance and improves its overall efficiency. The control strategy can realise maximum power point tracking and inject a sinusoidal low total harmonic distortion current to the grid. A 100 W prototype inverter has been built to verify operation and feasibility of the proposed control strategy.

Decoupling (probability)

Single stage

Single phase

Single-phase electric power

Power grid

Three-phase

10.1049/iet-pel.2016.0349

Cite

Citations (14)

Designing a compensating electronic circuit to enhance capacitive voltage transformer characteristics

Mohammad Hadi Zare Ahmad Mirzaei Hossein Askarian Abyaneh

Capacitive voltage transformer (CVT) is widely used to convert high voltage signals to low voltage ones for measurement, protection and control. It has poor dynamics which can lead to maloperation of protective relays. Moreover, CVT has a non-smooth frequency response and limited band width which make it inappropriate for system harmonic measurements. This paper proposes a new method for decreasing CVT voltage distortions and correcting CVT dynamic response as well as its steady state response. An electronic circuit is designed so as to reproduce CVT transients. The final output which is the summation of CVT voltage and the designed circuit voltage has considerably low distortions and is a replica of the input voltage. The proposed method is independent of the load and the Ferroresonance Suppression Circuit (FSC) connected to the CVT. Simulation results confirm the efficiency and accuracy of the proposed method. Finally, CVT percentage error for the proposed method is compared with the dynamic compensation method.

10.1109/pspc.2015.7094922

Cite

Citations (3)

A modified shear-lag model for prediction of stress distribution in unidirectional fibrous composites considering interphase

Journal of mechanics of materials and structures (2019)

Mohammad Hadi Zare M. Mondali

Interphase

10.2140/jomms.2019.14.97

Cite

Citations (0)

A Single-Phase Grid-Connected Photovoltaic Inverter Based on a Three-Switch Three-Port Flyback With Series Power Decoupling Circuit

IEEE Transactions on Industrial Electronics (2016)

Mohammad Hadi Zare Mustafa Mohamadian Reza Beiranvand

In this paper, a novel single-stage three-port inverter that connects photovoltaic (PV) panel to a single-phase power grid is introduced. In a single-phase grid-connected PV panel, the input power is constant during the line-frequency period, while the output power oscillates at double-line frequency. A series active power decoupling circuit utilizing thin-film capacitors is incorporated to a conventional flyback inverter to handle input and output power differences. Therefore, popularly low-reliable electrolytic capacitors are replaced with small long-lifetime thin film. The proposed inverter can extract the maximum power from PV, deliver a low total harmonic distortion sinusoidal current to the output, and decouple the input and output powers. The proposed power decoupling circuit shares the inverter main switch. Thus, these functions are achieved using just three switches and a simple control scheme which is applicable for both charging and discharging states. Operation principle and control strategy are discussed in detail. Experimental results based on a 100-W prototype inverter verify feasibility and functionality of the proposed inverter.

Decoupling (probability)

Grid-tie inverter

Solar micro-inverter

10.1109/tie.2016.2620100

Cite

Citations (61)