We report a macroscopic shrinkage by up to 30 vol % during electrochemical dealloying of Ag-Au. Since the original crystal lattice is maintained during the process, we suggest that the formation of nanoporous gold in our experiments is accompanied by the creation of a large number of lattice defects and by local plastic deformation.
The impact of severe plastic deformation by high-pressure torsion on the relaxation of the glassy and supercooled liquid states of Pd40Ni40P20 was investigated using a combination of differential scanning calorimetry, low-temperature heat capacity, and fluctuation electron microscopy. The changes in the calorimetric signals due to deformation and subsequent heat treatments were analyzed and a correlation between deformation (rejuvenation) and annealing (relaxation) was found in relation to medium-range order (MRO). Moreover, a coupling between the occurrence of an exothermic peak in the supercooled liquid state and specific changes in the MRO types were identified. These findings are comprehended in a potential energy landscape scheme offering a new approach for MRO engineering of glasses.
SH-SY5Y NEUROBLASTOMA cells were used to study the effect of retinoic acid (RA)-induced differentiation on the expression of gangliosides and neuronal markers. In the presence of 10 μM RA, more than 70% of the cells differentiate to a neuronal phenotype within 8 days. They extend long neuritic processes and show an enhanced immuno-expression of neurone-specific enolase (NSE), neurofilament protein (NF-M), and polysialic acid (PSA). SH-SY5Y cells were found to express at least 12 different gangliosides. RA-induced neuronal differentiation led to a decrease in the content of GM2, GD3, and GD2 and to a 3–7 fold increased concentration of the ganglio-tetraosyl gangliosides GM1, GD1a, GT1a, GD1b, and GT1b. Thus, RA-induced neuronal differentiation of SH-SY5Y cells is accompanied by ganglioside changes similar to those observed during embryonic neuronal differentiation.
Severe plastic deformation (SPD) is performed on a newly developed medium‐Mn steel with the composition of Fe–7.66Mn–2Ni–1Si–0.23C–0.05Nb (wt%) to achieve a nanocrystalline microstructure. The SPD process utilizes the high‐pressure torsion (HPT) technique, resulting in a nominal shear strain of approximately 36 000% after processing the disk for 10 turns. In X‐Ray diffraction line profile analysis, an increase in dislocation density to around 230 × 10 14 m −2 is observed. In addition, under high strains, a face‐centered cubic (fcc) secondary phase emerges within the body‐centered cubic (bcc) matrix. In analytical transmission electron microscopy, using energy‐dispersive X‐Ray spectroscopy, it is indicated that the secondary‐phase particles are enriched in Al, Mn, and Si. As the strain imposed during HPT increases, the simultaneous rise in dislocation density and nanostructuring lead to material hardening. However, the partial phase transformation from bcc to fcc contributes to material softening. As a result of these two opposite effects, the hardness exhibits a non‐monotonic variation with the shear strain, displaying, for 10 turns of HPT, a lower hardness compared to fewer turns, despite the continuous increase in dislocation density and decrease in crystallite size.
Neuroblastomas and cell lines derived from these tumors bear the oncodevelopmental antigen polysialic acid (PSA) bound to the neural cell adhesion molecule. Polysialyation of neural cell adhesion molecule can be achieved by two different polysialyltransferases, ST8SiaII and ST8SiaIV. This study was undertaken to investigate the pattern of polysialyltransferases expressed in the human neuroblastoma cell line SH-SY5Y. Reverse transcription-PCR showed simultaneous expression of the two enzymes, and in situ hybridization demonstrated that the polysialyltransferase mRNA expression parallels immunoreactivity with the PSA-specific monoclonal antibody 735. After retinoic acid-induced differentiation, only the PSA-positive, neuron-like cell type gave clear signals for ST8SiaII and ST8SiaIV in in situ hybridization, whereas both signals were drastically reduced in the weakly PSA-positive substrate adherent phenotype. Like the SH-SY5Y cells, a primary, PSA-positive neuroblastoma specimen revealed expression of the two polysialyltransferases. To investigate the role of PSA for cell growth and differentiation, SH-SY5Y cells were treated with the PSA-specific endo-N-acetylneuraminidase E. Although loss of PSA was accompanied with a marked reduction of cell growth, it did not interfere with retinoic acid-induced differentiation. Together, our results suggest that PSA surface expression is regulated on the level of polysialyltransferase transcription. Moreover, the similarity to the primary neuroblastoma tissue makes SH-SY5Y cells a suitable model system to examine further the role of polysialylation in tumor cell growth and the orchestration of PSA synthesis in neuroblastoma.
The nanocrystalline structure of an eutectoid steel after severe plastic deformation by High Pressure Torsion (HPT) was studied by means of High Resolution TEM (HRTEM) and Energy Filtered TEM (EFTEM). In an as-processed specimen nano-sized areas of modulated fringe contrast were revealed. It was shown, that in most cases the observed fringes can be explained as Moire patterns resulting from the overlapping of two lattices: normal iron and a highly distorted lattice with a structure similar to BCC iron. It seemed most likely that these distorted regions were transitional carbon-containing phases. Distortions due to dislocation networks were shown to be unlikely in this case. EFTEM investigation revealed a fairly uniform distribution of carbon in the HPT steel that corresponds well with our previous results about total cementite dissolution as a result of HPT, although some small carbon enrichments were seen, which may correspond to the distorted phases observed by HRTEM.
