Jingxia Wang

Technical Institute of Physics and Chemistry

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Trends

Author Order

Document Type

Co-Authors

Lei Jiang

Technical Institute of Physics and Chemistry

126

Yanlin Song

Beijing National Laboratory for Molecular Sciences

Tomiki Ikeda

Chinese Academy of Sciences

Jun‐Chao Liu

Nanchang University

Youzhuan Zhang

Chinese Academy of Sciences

Yuchen Yue

Technical Institute of Physics and Chemistry

Wenjie Yang

University of Chinese Academy of Sciences

Bo Guan

Chinese Academy of Sciences

Weihao Meng

Technical Institute of Physics and Chemistry

Jinming Zhou

Hebei Normal University

Cooperative Institutions

Chinese Academy of Sciences

306

University of Chinese Academy of Sciences

166

Beijing National Laboratory for Molecular Sciences

Institute of Chemistry

Technical Institute of Physics and Chemistry

University of Science and Technology of China

Central South University

Peking University

Sichuan University

Shanghai Jiao Tong University

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Field

Study on the Synthesis and Catalytic Oxidation of Chitosan Supported Fe( II) Complexes

Journal of Jining University (2011)

Jingxia Wang

Chitosan iron(Ⅱ) metal complexes have been synthesized and characterized.A preliminary experiment to explore its catalytic reaction conditions,visited the complex on the oxygen molecules cyclohexene oxidation catalyst.

Source

Cite

Citations (0)

Gamma-Irradiated Cuco-Based Nanocomposites as High-Performance Catalyst for Hydrogen Production and Tandem Hydrogenation

SSRN Electronic Journal (2022)

Ping Li Xusheng Yang Jiahao Wu Tong Ni Jingxia Wang

Non-precious bicomponent Cu-Co-based nanocomposites (CuCo 2 O 4 /CuO) were prepared by gamma-irradiation method for the hydrogen production and tandem hydrogenation of nitroarenes. Compared with the unirradiated one (CuCo 2 O 4 ), the γ-irradiated catalyst exhibited remarkable performance for the hydrogen production from ammonia borane (AB) hydrolysis and the nitroarenes hydrogenation. Hydrogen generation rate (HGR) for the γ-irradiated one is 856.3 mL·min -1 ·g cat- 1 , which is approximately two-fold than that for the conventional catalyst (only 397.1 mL·min -1 ·g cat -1 ). For most of screened substrates including those containing bifunctional groups, 100% yield of aim reduced products was obtained. Irradiated CuCo 2 O 4 /CuO was less affected (~10% activity decrease) after six runs. Notable chemo-selectivity was observed for the irradiated one. Distinguishable components between the γ-irradiated sample and the unirradiated one suggests that γ-ray irradiation contributes to catalyst reconstruction, leading to great activity improvement.

Tandem

10.2139/ssrn.4177570

Cite

Citations (0)

BIOINSPIRED FABRICATION OF FUNCTIONAL POLYMER PHOTONIC CRYSTALS

Acta Polymerica Sinica (2010)

Youzhuan Zhang Zhirong Li Yongmei Zheng Jingxia Wang Yanlin Song

10.3724/sp.j.1105.2010.10217

Cite

Citations (5)

Career Decision-Making Self-Efficacy and Professional Commitment Among Master Nursing Students

Western Journal of Nursing Research (2016)

Jingxia Wang Rui Guo Minhui Liu Xiaofei Zhang Lu Ren

Developing countries face a shortage of nurses with higher education, such as those with a master’s degree. However, few studies have investigated the interaction between career decision and professional commitment (PC) of nursing students, especially for postgraduates. This study performed correlation analysis for career decision-making self-efficacy (CDMSE) and PC of 545 nursing postgraduate students from nursing schools at 19 universities or colleges throughout mainland China, who came from different regions, and possessed different years of study and different types of degrees as well as part-time job experiences. Data reliability and validity were confirmed for both Career Decision-Making Self-Efficacy Scale for university students (CDMSE-R) and Professional Commitment Questionnaire (PCQ). We found positive correlations between factors of PC and CDMSE. The score of CDMSE was different between regions, degree types, grades, and part-time job experiences. According to our results, we suggest nursing education or career advisory services should promote the PC of nursing students according to factors of their CDMSE scores.

Self-Efficacy

10.1177/0193945916682236

Cite

Citations (21)

Photo/heat/electricity/pressure-driven photonic pattern with multimode memory effect

Chemical Engineering Journal (2022)

Yuanyuan Shang Jun‐Chao Liu Bo Guan Jinbao Guo Tomiki Ikeda

Bistability

Azobenzene

10.1016/j.cej.2022.141215

Cite

Citations (11)

Inkjet printed colloidal photonic crystal microdot with fast response induced by hydrophobic transition of poly(N-isopropyl acrylamide)

Journal of Materials Chemistry (2012)

Libin Wang Jingxia Wang Yu Huang Meijin Liu Minxuan Kuang

This paper presents rapid response colloidal photonic crystal (PC) microdots fabricated by inkjet printing, which demonstrate a fastest response of ca. 1.2 s to water vapor. This remarkable improvement of response rate could be attributed to the combined effects of the intrinsic small size of the inkjet microdots and the hydrophobic transition of poly(N-isopropyl acrylamide) (PNIPAm) above its lower critical solution temperature (LCST). The reversible phase transition of PNIPAm modifies the hydrophilic–hydrophobic balance of the polymer interface, which leads to the modulation of wetting states/adhesion properties of adsorbed water on the polymer segments, resulting in the remarkable improvement of response rate. Moreover, the optimal response performance (including signal strength and response sensitivity) of the printed PC microdot is achieved by the coordination of a well-ordered latex assembly and full infiltration of the responsive polymer in the latex interstices. This simple fabrication of functional colloidal PC microdots opens new avenues for the construction of advanced microanalysis and microsensing devices. In addition, improving the response rate by the phase transition of the polymer segments is promising for the creation of high-performance sensors.

Poly(N-isopropylacrylamide)

Colloidal crystal

10.1039/c2jm33411a

Cite

Citations (95)

Meniscus‐Assisted Coating with Optimized Active‐Layer Morphology toward Highly Efficient All‐Polymer Solar Cells

Advanced Materials (2021)

Yuchen Yue Bing Zheng Wenjie Yang Lijun Huo Jingxia Wang

Morphology control is the key to engineering highly efficient solution-processed solar cells. Focusing on the most promising application-oriented photovoltaic all-polymer solar cells (all-PSCs), herein a facile and effective meniscus-assisted-coating (MAC) strategy is reported for preparing high-quality blend films with enhanced crystallinity and an interpenetrating nanofiber network morphology. The all-PSCs based on MAC exhibit excellent optoelectronic properties with efficiencies exceeding 15%, which is the best performance of solution-printing-based all-PSCs, as well as better stability. The crystallization kinetics of the polymer blend film is investigated by in situ UV-vis absorption spectroscopy, and the result explains the linear relationship between the meniscus advance speed and the crystallinity (crystallization rate) of the polymer. To verify the compatibility and universality of this strategy, the MAC strategy is applied to the other three binary systems. By precisely controlling the meniscus advancing speed, 1 cm2 all-PSC devices whose efficiencies exceed 12% are fabricated. Such progress demonstrates that the application of the MAC strategy is a promising approach for the fabrication of high-efficiency all-PSCs.

10.1002/adma.202108508

Cite

Citations (34)

Fabrication of Phase-Change Polymer Colloidal Photonic Crystals

Journal of Nanomaterials (2014)

Tianyi Zhao Youzhuan Zhang Jingxia Wang Yanlin Song Lei Jiang

This paper presents the preparation of phase‐change polymer colloidal photonic crystals (PCs) by assembling hollow latex spheres encapsulated with dodecanol for the first time. The monodispersed hollow latex spheres were obtained by phase reversion of monodispersed core‐shell latex spheres in the n‐hexane, which dissolves the PS core and retains the PMMA/PAA shell. The as‐prepared phase‐change colloidal PCs show stable phase‐change behavior. This fabrication of phase‐change colloidal PCs would be significant for PC’s applications in functional coatings and various optic devices.

10.1155/2014/702089

Cite

Citations (19)

Fluorescence Retention of Organosilane-polymerized Carbon Dots Inverse Opals in CuCl Suspension

Chinese Journal of Polymer Science (2018)

Pingping Wu Jun‐Chao Liu Zheng Xie Jinshan Guo Jingxia Wang

Suspension

Colloidal crystal

10.1007/s10118-018-2126-7

Cite

Citations (4)

Photochemical switching behavior of azo-functionalized mesoporous silica photonic crystals