본 연구에서는 헬리콥터의 전진비행성능 향상에 필수적인 로터블레이드의 동적실속성능을 향상시키기 위한 수동제어기법에 대한 연구를 수행하였다. 로터블레이드의 동적실속성능을 향상시키기 위해서는 블레이드 익형에 발생하는 유동박리에 대한 제어를 통해 양력 특성과 피칭모멘트 특성을 동시에 향상시켜야만 한다. 본 연구에서는 실제구현이 용이한 고정 앞전Droop과 Gurney 플랩을 심한 동적실속영역에 대해 동시에 적용하여 기존의 동적실속 제어기법에 비해서 탁월한 양력성능 향상 및 피칭 모멘트 성능 향상을 얻을 수 있음을 확인하였다. To achieve the advanced forward flight performance of helicopter, the passive control methods for enhancement of the dynamic stall characteristics of rotor blades are studied. To enhance the dynamic stall characteristics of the rotor blades, it is essential to improve the lift performance and the pitching moment performance simultaneously with the control of the separation on the rotor blades. For this point of view, both the fixed droop leading edge and the Gurney flap which are simply realized are used for control of the dynamic stall in severe dynamic stall conditions. From this study, the combination of both passive control methods showed dramatic enhancement of lift and pitching moment performance in dynamic stall than previous research results.
비압축성 평균 Navier-Stokes 방정식에 $\varepsilon{-SST}$ 난류 모델을 적용하여 정사각주 주위 유동과 지면의 간극 유동을 해석하였다. 지면이 운동할 경우에는 지면의 박리 전단층의 강도가 약화되어 사각주 상/하부의 박리 전단층 상호 작용을 촉진시키므로 고정 지면에 비하여 더 낮은 간극에서도 와류 배출이 발생한다. 지면 효과를 고려할 경우 고정 지면의 경우와는 달리 지면의 박리 거품이 존재하지 않게 되고, 이로 인하여 2차 박리 주파수는 나타나지 않는다. 이와 더불어 지면이 운동할 경우 고정 지면에 비해 더 높은 와류 배출 주파수와 공력 계수가 나타남을 확인하였다. Incompressible Reynolds-averaged Navier-Stokes equations with $\varepsilon{-SST}$ turbulence model are adopted for the investigation of the flow fields between the square cylinder and the ground. When the grounds moves, the diminish of the shear layer intensity on the ground promotes the interaction between the lower and the upper separated shear layer of the cylinder. Hence vortex shedding occurs at the lower gap height than stationary ground. In the moving ground, the secondary shedding frequency disappears due to the absence of the separation bubble on the ground which exists in the stationary ground. In addition, the shedding frequency and aerodynamic coefficients in the moving ground become higher than those of the stationary ground.
To demonstrate the benefits of a combined nose droop and Gurney flap for improving dynamic stall and poststall aerodynamic characteristics of a rotor airfoil, numerical investigations and design optimization have been performed. As a means of passive flow control, a fixed nose droop has been deliberately employed together with a Gurney flap. For shape optimization, droop location and droop angle were selected as design variables for the fixed nose droop, and the flap length was chosen as a design variable for the Gurney flap. Bousman’s function plot was employed to define the objective function and constraint conditions. A feasible direction-based optimizer and a higher-order response surface method were harnessed to handle the highly nonlinear properties of dynamic stall. By the use of this methodology, optimum design was carried out to enhance lift and pitching moment characteristics simultaneously; at the same time, the unfavorable effects of the overall movement of the pitching moment coefficient induced by droop and the Gurney flap was reduced. It is also proved that by utilizing a 22.7-deg droop at the 0.275 chord droop position and a 1.14% chord Gurney flap, the stall can be delayed by a maximum lift coefficient increased by 13%, a maximum negative pitching moment reduced by 60%, and the lift-to-drag ratio increased accordingly. The present combined passive control methods and design result show significant improvement of aerodynamic performance in Bousman’s plot in terms of lift and pitching moment.
The direct fluorination of polymers is a heterogeneous reaction using the mixture of and inert gas. In general, the resulting fluorinated polymers have good barrier property chemical stability similar to those of the fluoro-polymers, and could be prepared from the simple process. In this study, the polysulfone dense films were surface fluorinated using the direct fluorination technique and gas permeability and selectivity of the prepared membranes were measured with varying both concentration and reaction time. The introduction of was confirmed by X-ray photoelectron spectroscopy (XPS), water contact angles, and atomic force microscopy (AFM). As the increased, the permeability decreased while the selectivities for , , and He gases relative to increased.
ABSTRACT The present study focuses on the effects of the aspect ratio of a rectangular cylinder and the gap height from the ground to the unsteady wake fields around the rectangular cylinder near the ground. The results indicate that the vortex begins to shed by the interaction of the separated shear layer on the upper surface of the cylinder with the upwash flow in the gap region. Based on this investigation, simple passive control methods consisting of attached vertical or horizontal plates on the lower surface of the rectangular cylinder are introduced to reduce the aerodynamic drag as well as to suppress the vortex-induced oscillation. Acknowledgments The authors thank "Brain Korea 21 project," and would like to acknowledge support from the Korea Institute of Science and Technology Information (KISTI) under "The Sixth Strategic Supercomputing Support Program." The use of the computing system of the Supercomputing Center is also greatly appreciated.
지면엔 근접한 사각주 후면에서 발생하는 비정상 와류 배출은 지상 운송체, 교량, 건물 등의 항력 증가뿐 아니라, 동안정성에도 큰 영향을 미친다. 비압축성 평균 Navier-Stokes 방정식에 수정된 ${\varepsilon}-SST$ 난류 모델을 적용하여 사각주 하부와 지면과의 간극 유동을 해석하였다. 사각주 후류에서 와류가 발생하는 경우에는 간극에서의 평균 최대 속도가 억제된 경우에 비하여 높으며, 또한 최대 속도의 위치 또한 사각주 하부에 근접한 것을 확인하였다. 본 연구에서는 사각주 하부에 수평, 수직의 펜스를 설치하는 수동 제어기법을 적용하여 사각 주 후류의 와류 배출용 억제할 수 있다. Unsteady vortex shedding behind a rectangular cylinder near a wall influences both increasing of drag and dynamic stability of heavy vehicle, bridge or building. Incompressible Averaged Navier-Stokes equation with modified ${\varepsilon}-SST$ turbulence model is adapted for investigating the flow field between the rectangular cylinder and the wall. In case the vortex shedding happens, not only the averaged maximum velocity is higher than other cases, but the position of the maximum velocity is closer to the lower surface of rectangular cylinder. On this study, it is confirmed that the vortex shedding behind a rectangular cylinder can be suppressed by the passive control method added by horizontal and vertical fences to the lower surface of rectangular cylinder.
지면 근처에 존재하는 뭉뚝한 물체의 유동장 이해는 자동차 및 항공 업계에 매우 중요한 분야이다. 이를 위해 비압축성 평균 Navier-Stokes 방정식에 $\varepsilon{-SST}$ 난류 모델을 적용하여 정사각주와 이동 지면의 간극 유동을 해석하였다. 비정상 진동을 억제하기 위하여 사각주 하부에 수직/수평의 펜스 설치 효과를 연구하였다. 지면이 운동할 경우에는 지면의 박리 전단층의 강도가 약화되어 사각주 상/하부의 박리 전단층 상호 작용을 촉진시키므로 고정 지면에 비하여 더 낮은 간극에서도 와류 배출이 발생한다. Understanding of the flow past a bluff body close to a moving ground is very important in automobile and aeronautical fields because of aerodynamic characteristic and instability induced by unsteady vortex shedding. The passive control method that mounted the vertical and horizontal plates at the lower surface of the cylinder is studied to suppress the unsteady oscillation motion. When the grounds moves, the diminish of the shear layer on the ground promotes the interaction between the lower and the upper separated shear layers of the cylinder, hence vortex shedding occurs at the lower gap height than the stationary ground.
'%3e%3cg id='b'%3e%3cpath id='a' stroke='%23000' stroke-width='2' d='M-6-25H6m-12 3H6m-12 3H6'/%3e%3cuse xlink:href='%23a' y='44'/%3e%3c/g%3e%3cpath stroke='%23fff' d='M0 17v10'/%3e%3ccircle r='12' fill='%23cd2e3a'/%3e%3cpath fill='%230047a0' d='M0-12A6 6 0 0 0 0 0a6 6 0 0 1 0 12 12 12 0 0 1 0-24z'/%3e%3c/g%3e%3cg transform='rotate(-123.69)'%3e%3cuse xlink:href='%23b'/%3e%3cpath stroke='%23fff' d='M0-23.5v3M0 17v3.5m0 3v3'/%3e%3c/g%3e%3c/svg%3e)