Transport and deposition of nanoparticles (NPs) have drawn great attention in different fields of engineering in recent years because of their potential risk to the environment. In this study, mobility of aluminum oxide NP, one of the most popular metal oxide NPs, was studied in synthetic saturated porous media. The impacts of ionic strength using monovalent (NaCl) and divalent (MgCl2) salt solution, pH, and NPs concentrations on nano-alumina mobility were investigated. The experimental results showed that the transport of nano-alumina was influenced by ionic strength; the highest mobility was observed at the 0.01 M solution and decreased by increasing ionic strength. Moreover, the suspension containing alumina NPs presented the best mobility behavior in the acidic solution (pH = 2) in comparison with neutral and basic solutions. Consequently, transport of NPs with particle size distribution lower than 100 nm through porous media was facilitated at the acidic, low ionic strength condition. In addition, faster elution occurred when the influent concentration was increased from 0.1 wt% to 0.3 wt%. Finally, it is expected that ionic strength, pH of solution, and NPs concentration will be key parameters to control the nano-alumina mobility.
In this work, N, O-carboxymethyl chitosan (CMCS) samples from virgin chitosan (CS) were synthesised and CMCS/polyethylene oxide (PEO) (50/50) blend nanofibrous samples were successfully electrospun from their aqueous solution. The electrospinning conditions to achieve smooth and fine diameter nanofibrous mats were optimised via D-optimal design approach. Afterwards, vitamin C and phenytoin sodium (PHT-Na) were added to these samples for producing wound dressing materials. H-nuclear magnetic resonance, scanning electron microscopy and Fourier transform infrared tests for the evaluation of functionalised CS, morphology and biodegradability studies of CMCS/PEO blend nanofibrous samples were applied. The kinetic and drug release mechanism for vitamin C and PHT-Na drug-loaded electrospun samples were also investigated by UV-vis spectrophotometer and high performance liquid chromatography, respectively. The results showed an approximately similar drug release rate of the two drugs and followed Higuchi's kinetic model. The stem cells viability and their adhesion on the surface of the samples containing PHT-Na and vitamin C were carried out using MTT assay and the best cells' biocompatibility was obtained using both drugs into the CMCS/PEO nanofibrous samples. Moreover, the in vivo animal wound model results revealed that the electrospun samples containing vitamin C and PHT-Na (1%) had a remarkable efficiency in the wounds' closure and their healing process compared with vitamin C/PHT-Na (50/50) ointment. Finally, the histology observations showed that the wound treated with optimised electrospun samples containing two drugs enabled regeneration of epidermis layers due to collagen fibres accumulation followed by granulating tissues formation without necrosis.
A fast and efficient method was developed for the extraction and determination of organophosphorus pesticides in water samples. Organophosphorus pesticides were extracted by solid-phase extraction using magnetic multi-walled carbon nanotubes and determined by gas chromatography with ion-trap mass spectrometry. Parameters affecting the extraction were investigated. Under optimum conditions of the method, 10 mg magnetic multi-walled carbon nanotubes were added into 10 mL sample. After 2 min, adsorbent particles settled at the bottom of test tube with a magnet. After removing aqueous supernatant, the analytes were desorbed with acetonitrile. Then, 70 μL of acetonitrile phase was injected into the gas chromatography and mass spectrometry system that had an ion-trap analyzer. To achieve high sensitivity, the large-volume-injection technique was used with a programmed temperature vaporization inlet, and the ion-trap mass spectrometer was operated in single ion storage mode. Under the best conditions, the enrichment factors and extraction recoveries were in the range of 113-124 and 74-103%, respectively. The limits of detection were between 3 and 15 ng/L, and the relative standard deviations were < 10%. This method was successfully used for the determination of organophosphorus pesticides in dam water, lagoon water, and river water samples with good reproducibility and recovery.
The electrospinning method was used to prepare novel PSM/EC microfiber characterized by SEM and BET analyses. Subsequently, the batch adsorption capacity of the PSM/EC microfiber was investigated for the removal of lead (ΙΙ) from aqueous solution. The effect of adsorbent concentration, initial solution pH, contact time and temperature on the adsorption process was studied. It was found that the double-exponential model was a better fit for the kinetic data. The equilibrium data were better predicted by the Liu Isotherm model with adsorption capacity of 44.6 (mg/g) rather Langmuir and Freundlich. The process is spontaneous and endothermic due to thermodynamic parameters.
'%3e%3cg id='e'%3e%3cg id='c' fill='none' stroke='%23fff' stroke-width='2'%3e%3cpath id='b' d='M0 1h26M1 10V5h8v4h8V5h-5M4 9h2m20 0h-5V5h8m0-5v9h8V0m-4 0v9' transform='scale(1.4)'/%3e%3cpath id='a' d='M0 7h9m1 0h9' transform='scale(2.8)'/%3e%3cuse xlink:href='%23a' y='120'/%3e%3cuse xlink:href='%23b' y='145.2'/%3e%3c/g%3e%3cg id='d'%3e%3cuse xlink:href='%23c' x='56'/%3e%3cuse xlink:href='%23c' x='112'/%3e%3cuse xlink:href='%23c' x='168'/%3e%3c/g%3e%3c/g%3e%3cuse xlink:href='%23d' x='168'/%3e%3cuse xlink:href='%23e' x='392'/%3e%3c/g%3e%3cg fill='%23da0000' transform='matrix(45 0 0 45 315 180)'%3e%3cg id='f'%3e%3cpath d='M-.548.836A.912.912 0 0 0 .329-.722 1 1 0 0 1-.548.836'/%3e%3cpath d='M.618.661A.764.764 0 0 0 .422-.74 1 1 0 0 1 .618.661M0 1l-.05-1L0-.787a.31.31 0 0 0 .118.099V-.1l-.04.993zM-.02-.85 0-.831a.144.144 0 0 0 .252-.137A.136.136 0 0 1 0-.925'/%3e%3c/g%3e%3cuse xlink:href='%23f' transform='scale(-1 1)'/%3e%3c/g%3e%3c/svg%3e)
