We report on nano-infrared (IR) imaging studies of confined plasmon modes inside patterned graphene nanoribbons (GNRs) fabricated with high-quality chemical-vapor-deposited (CVD) graphene on Al2O3 substrates. The confined geometry of these ribbons leads to distinct mode patterns and strong field enhancement, both of which evolve systematically with the ribbon width. In addition, spectroscopic nano-imaging in mid-infrared 850-1450 cm-1 allowed us to evaluate the effect of the substrate phonons on the plasmon damping. Furthermore, we observed edge plasmons: peculiar one-dimensional modes propagating strictly along the edges of our patterned graphene nanostructures.
We developed means to produce wafer scale, high-quality graphene films as large as 3 inch wafer size on Ni and Cu films under ambient-pressure and transfer them onto arbitrary substrates through instantaneous etching of metal layers. We also demonstrated the applications of the large-area graphene films for the batch fabrication of field-effect transistor (FET) arrays and stretchable strain gauges showing extraordinary performances. Transistors showed the hole and electron mobilities of the device of 1,100 cm2/Vs and 550 cm2/Vs at drain bias of -0.75V, respectively. The piezo-resistance gauge factor of strain sensor was ~6.1. These methods represent a significant step toward the realization of graphene devices in wafer scale as well as application in optoelectronics, flexible and stretchable electronics.
Uniaxial materials whose axial and tangential permittivities have opposite signs are referred to as indefinite or hyperbolic media. While hyperbolic responses are normally achieved with metamaterials, hexagonal boron nitride (hBN) naturally possesses this property due to the anisotropic phonons in the mid-infrared. Using scattering-type scanning near-field optical microscopy, we studied polaritonic phenomena in hBN. We performed infrared nano-imaging of highly confined and low-loss hyperbolic phonon polaritons in hBN. The polariton wavelength was shown to be governed by the hBN thickness according to a linear law persisting down to few atomic layers [1]. Additionally, we carried out the modification of hyperbolic response in meta-structures comprised of a mononlayer graphene deposited on hBN [2]. Electrostatic gating of the top graphene layer allows for the modification of wavelength and intensity of hyperbolic phonon polaritons in bulk hBN. The physics of the modification originates from the plasmon-phonon coupling in the hyperbolic medium. Furthermore, we demonstrated the "hyperlens" for subdiffractional focusing and imaging using a slab of hBN [3]. References [1] S. Dai et al., Science, 343, 1125 (2014). [2] S. Dai et al., Nature Nanotechnology, 10, 682 (2015). [3] S. Dai et al., Nature Communications, 6, 6963 (2015).
We present a pressure sensor based on the piezoresistive effect of graphene. The sensor is a 100 nm thick, 280 μm wide square silicon nitride membrane with graphene meander patterns located on the maximum strain area. The multilayer, polycrystalline graphene was obtained by chemical vapor deposition. Strain in graphene was generated by applying differential pressure across the membrane. Finite element simulation was used to analyze the strain distribution. By performing electromechanical measurements, we obtained a gauge factor of ∼1.6 for graphene and a dynamic range from 0 mbar to 700 mbar for the pressure sensor.
A novel graphene-on-organic film fabrication method that is compatible with a batch microfabrication process was developed and used for electromechanically driven microactuators. A very thin layer of graphene sheets was monolithically integrated and the unique material characteristics of graphene including negative thermal expansion and high electrical conductivity were exploited to produce a bimorph actuation. A large displacement with rapid response was observed while maintaining the low power consumption. This enabled the successful demonstration of transparent graphene-based organic microactuators.