Xie Jindong

Beijing Normal University

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Trends

Author Order

Document Type

Co-Authors

Tonghe Zhang

General Hospital of Shenyang Military Region

Ji Chengzhou

Beijing Normal University

Sun Guiru

Qingdao University of Science and Technology

Jun Chen

Tianjin Medical University General Hospital

Huixing Zhang

TianjinSino-German University of Applied Sciences

Wei Fuzhong

Beijing Normal University

Y. Gao

Oita University

Wang Daokuan

China University of Geosciences

Zhou Yuefei

Wang Anmin

Tianjin Chengjian University

Cooperative Institutions

Beijing Normal University

General Research Institute for Nonferrous Metals (China)

Beijing Radiation Center

China University of Mining and Technology

Tianjin Medical University

Ningxia Medical University

Qingdao University of Science and Technology

Tianjin Medical University General Hospital

Army Medical University

Soochow University

Author Statistics

Papers

Citation

H-Index

i-10 index

Research Field

A study of pulsed high flux Ti, Mo, V and Y ion implantation for surface modification of resistances in wear, corrosion and oxidation

Vacuum (1994)

Tonghe Zhang Ji Chengzhou Xie Jindong Jun Chen Wei Fuzhong

10.1016/0042-207x(94)90217-8

Cite

Citations (7)

Influence of the structure of implanted steel with Y, Y + C and Y + Cr on the behaviors of wear, oxidation and corrosion resistance

Surface and Coatings Technology (1995)

Tonghe Zhang Xie Jindong Ji Chengzhou Jun Chen Hong Xu

10.1016/0257-8972(94)02337-9

Cite

Citations (33)

Study on Two-step Casing for Strips and Cut Strips of Burley Tobacco

Tobacco Science & Technology (2012)

Wang Daokuan Zhou Yuefei Xie Jindong

To improve casing utilization and casing uniformity,a two-step burley tobacco casing process was adopted,at the first casing step,burley strips were cased after conditioning,heating and loosening;at the second casing step,the cut strips were cased.The preferable casing proportion at each casing step was investigated as well.The results showed that comparing with traditional twice strip casing,the two-step casing raised the casing uniformity coefficient from 53.52% to 90.14% and the effective utilization rate of casing from 61.19% to 88.25% when the ratio of strip casing to cut strip casing was 3∶1.

STRIPS

10.3969/j.issn.1002-0861.2013.01.003

Cite

Citations (0)

Metallic ion implantation by using a MEVVA ion source

Radiation effects and defects in solids (1994)

Ji Chengzhou Tonghe Zhang Huixing Zhang Xie Jindong Wang Anmin

Abstract Metallic ions (Ti, Mo, W, V, Ni, Y, Fe and Al) extracted from a MEVVA source have been implanted up to high doses (>1 × 1017 cm−2) into Al and H13 steel. Because of beam heating, rather low energy ions could penetrate quite deeper in the substrates than predicted, stable intermetallic compounds appear as fine precipitates in the doped region, and hence the retained concentration of implants even exceeds the sputter-limited maximum. Multiply charged beam, enhanced diffusion and chemical reaction give great influences to the concentration distribution of implants. All these features are strongly dependent on the chosen ion-target combination.

Vacuum arc

10.1080/10420159408229015

Cite

Citations (10)